TS NO.:TS-048
oem
31331090612
31331091709
31331090613
Applicable vehicle Name:
BMW - x5728i, z4740i, 750i
Inner diameter: 62 outer diameter: 85 height: 12
1. The crane operator guides the driver to move the rotary table slowly to the main installation position. According to the amount of anchor bolts, the car driving is moved to adjust the accuracy. The wholesale of European shock absorber bearings is reduced. The crane operator should strictly follow the lifting worker's command should rise sharply drop sharply. The matching of the two vehicles should be inseparable, so as to avoid safety accidents caused by poor operation poor coordination.
2. When supporting the outer anchor bolts, two M35 round steel bars (according to the height width ratio of the rotary table the supporting surface) are respectively used to point to the parts, the symmetry is set on the base the supporting anchor bolt hole wall, so that the driver can correctly guide the alignment accuracy. In addition, two cutters are prepared to observe the length of the round steel, how the European shock absorber bearing supplier matches the upper side of the base The item will be cut off immediately until the base is fully implemented.
3. Immediately install all the staff to install the anchor bolts. After the foundation bolts are installed, cut off the correct guide round steel.
4. It should be tightened by hand according to the symmetry of field force, then torque wrench should be used after tightening. Oil based marking pen should be used to mark each time to prevent leakage of tightening.